CANOGA PERKINS CanogaOS Command Reference - Manual (Page 371)

CanogaOS Command Line Reference Revision 1.02
Proprietary & Confidential Canoga Pertkins Metro Ethernet Switches Page 371 of 855
19.3 match community
Use this command to specify the community to be matched.
Use the no parameter with this command to remove the community list entry.
Communities are used to group and filter routes. They are designed to provide the ability to
apply policies to large numbers of routes by using match and set commands. Community lists
are used to identify and filter routes by their common attributes.
Use the match community command to allow matching based on community lists.
The values set by the match community command overrides the global values. The route
that does not match at least one match clause is ignored.
Note:
This command is valid only for BGP.
19.3.1.1 Command Syntax
match community WORD
no match community
19.3.1.2 Syntax Description
WORD Specifies the Community-list name.
19.3.1.3 Command Mode
Route-map mode
19.3.1.4 Defaults
No match community is specified by default.
19.3.1.5 Examples
Switch# configure terminal
Switch(config)# route-map myroute permit 3
Switch(config-route-map)# match community mylist