How to perform a basic scan, For details, refer to – Ricoh fi-8040 Desktop Scanner User Manual
Page 69
How to Perform a Basic Scan
This section explains how to perform a basic scan.
ATTENTION
●
Depending on the connection method of the scanner, use only the USB cable to connect to a
computer or use only a LAN cable to connect to a network device. Do not use both cables at the
same time.
●
You cannot use a scanner in multiple ways at the same time.
For details about how to switch the usage method of the scanner, refer to
the Scanner Is Used (page 411)
.
HINT
When scanning with the scanner connected to a computer via a network, the image quality is lower
than when scanning with the scanner connected via a USB cable because the image transfer speed is
prioritized.
In the scanner driver, you can set the image quality to the same level as the level that is set when
scanning with the scanner connected via a USB cable. For details, refer to the help for the scanner
driver.
●
Using the Scanner Connected to a Computer
Start scanning with one of the following methods.
●
●
●
Using the Scanner by Itself (DirectScan)
Start scanning with the following method.
●
Processing a Job (DirectScan) (page 81)
69