Ricoh fi-8040 Desktop Scanner - Manual (Page 332)

Fill in the specified area with white.
(1): Top = 0 to 15 mm
(2): Bottom = -7 to 7 mm
(3): Right = 0 to 15 mm
(4): Left = 0 to 15 mm
(in 1 mm increments)
ATTENTION
Note that if the target range of page edge filler is too wide, some characters near the edge
may appear missing.
HINT
● You can change the background color to black or white in the scanner driver.
For details, refer to the help for the scanner driver.
● Depending on the value you specify for the bottom margin of [Page Edge Filler (ADF)], the
page edge filler function operates as follows:
- 1 to 7 mm
Fills in the specified area with the background color from the bottom edge of the image
towards the inside.
- -1 to -7 mm
Outputs the image without filling in the specified area with the background color from the
bottom edge of the image towards the outside. (Outputs the image with the specified area
added when [Page End Detection] is set in the scanner driver.)
● This setting can also be configured in the scanner driver.
In such a case, the page edge filler of the scanner driver is used on the image which the
scanner already filled in the edges.
Scanner Settings (Software Operation Panel)
332