Ricoh fi-8040 Desktop Scanner - Manual (Page 191)

ADF Open
If the ADF is opened during a scan and closed after the scan is canceled, the [Error] screen on the
touch screen will display the following error code along with the corresponding details and
solution.
Error Code Error Details and the Solution
U4:40 ADF Open
HINT
The [Error] screen does not display the code when the ADF is opened.
Also, note that operations on the touch screen are disabled while the ADF is open.
Remove the document from the ADF, and close the ADF.
Confirm that the ADF is closed properly.
Fully close the ADF, then confirm that "ADF open" without an error code is not displayed.
For more details about opening and closing the ADF, refer to
Opening/Closing the ADF (page 65) .
Being Used by Others
The scanner is already being used.
● Make sure that another application is not using the scanner.
● Make sure that the connection method of the scanner is correct.
● Make sure that no operations are being performed on the touch screen of the scanner.
● Make sure that resident applications on the computer are not using the scanner.
For example, the following applications may be occupying the scanner.
- PaperStream Capture
- PaperStream ClickScan
- Button Event Manager ([Watch Button Event] is enabled)
The Scanner Is in Doc Counting Mode.
The Scanner is in "Doc Counting mode" and therefore scanning cannot be performed.
Close the [Document Count] screen on the touch screen of the scanner to exit the Doc Counting
mode.
No Paper
No document has been loaded.
Load a document in the ADF paper chute (feeder).
Scanning Has Been Stopped by the User
Scanning has been stopped by the user.
Troubleshooting
191