Ricoh fi-8040 Desktop Scanner User Manual
Page 44
→
[Scanner Settings]
→
[Admin Password]
HINT
When the scanner is connected to a network, the network settings can be changed in fi Series
Network Settings.
For details, refer to
Network Settings (fi Series Network Settings) (page 359)
8
Check the network connection status for the scanner.
For details, refer to
How to Check the Network Connection for the Scanner (page 412)
.
9
Install necessary software to the computer which is to be connected to the scanner.
For details about the software and how to install the software, refer to
Prepare the bundled Setup DVD-ROM.
ATTENTION
If an old version of the software is installed, uninstall it first.
For details, refer to
Uninstalling the Software (page 414)
.
a
Insert the bundled Setup DVD-ROM into the DVD drive.
The [fi Series Setup] window appears.
b
Start the installation by following the instructions displayed in the screen.
It is recommended that you select [Installation (Recommended)].
10
Configure the settings to use the scanner on the computer.
Use Scanner Selection Tool to select a scanner to be used.
For details, refer to the Network Setup Tool for fi Series Help.
HINT
Scanner Selection Tool automatically starts up when the installation of Network Setup Tool for
fi Series is complete. If Scanner Selection Tool does not start up, refer to
Scanner Selection Tool (page 413)
.
11
Check whether the scanner is ready to start scanning.
For details, refer to
How to Perform a Basic Scan (page 69)
Scanner Setup
44