Ricoh fi-8040 Desktop Scanner User Manual
Page 45
Using the Scanner Connected to a Computer via a USB Cable
This section explains the setup procedure for using the scanner connected to a computer via a USB
cable.
About the procedure from unpackaging the scanner to turning the power on, refer to Getting Started.
1
Turn on the scanner.
For details, refer to
How to Turn the Power ON (page 61)
2
In the [Display language] screen, select a language, and press the [Next] button.
3
When the [Limited Warranty Guide] screen appears, confirm the displayed information and
press the [Next] button.
4
In the [Startup Mode] screen, select a startup mode and press the [Next] button.
5
In the [Select Usage] screen, select [Use the scanner connected to a computer] and press the
[Complete] button.
6
Install necessary software to the computer which is to be connected to the scanner.
For details about the software and how to install the software, refer to
Prepare the bundled Setup DVD-ROM.
ATTENTION
If an old version of the software is installed, uninstall it first.
For details, refer to
Uninstalling the Software (page 414)
.
a
Insert the bundled Setup DVD-ROM into the DVD drive.
The [fi Series Setup] window appears.
b
Start the installation by following the instructions displayed in the screen.
It is recommended that you select [Installation (Recommended)].
Scanner Setup
45