Ricoh fi-8040 Desktop Scanner - Manual (Page 136)

Load the document face-down in the ADF paper chute (feeder).
For details, refer to How to Load Documents (page 88) .
3 On the touch screen, press the [Send by E-mail] button.
4 In the [Select Address] screen, press the desired addresses and press the [OK] button.
You can select up to 25 addresses.
HINT
● When adding, changing, or deleting addresses, refer to Adding/Changing/Deleting an
Address when Sending Images by Email (page 142) .
● If no address is specified, the screen to confirm whether to add an address is displayed. Press
the [Yes] button to add an address.
● When you use a CA certificate for communication with the SMTP server, set it in fi Series
Network Settings.
For details, refer to
Network Settings (fi Series Network Settings) (page 359) .
5 In the [Scan Settings] screen, change the settings as needed and press the [OK] button.
To configure the scan settings in detail, press the [Advanced settings] button.
For details about the scan settings, refer to
Scan Settings (page 260) .
6 In the [Ready to scan] screen, press the [Scan] button.
Scanning starts.
HINT
When [Continue scanning] is enabled in the scan settings, the [Scan] button appears on the
[Ready to scan] screen after scanning is complete.
To continue scanning documents, load the documents in the ADF paper chute (feeder) and
press the [Scan] button.
7 When the [Complete Scan] button appears after scanning, press the button.
Various Ways to Scan (DirectScan)
136