Ricoh fi-8040 Desktop Scanner - Manual (Page 265)

Uses the ultrasonic sensors inside the scanner to monitor the documents during
feeding, and detects overlapped documents according to the deviation of the
reflected ultrasonic waves.
This is the factory default setting.
- Length
Monitors the document length during feeding, and detects overlapped documents
according to the deviation of detected lengths.
ATTENTION
Do not scan a batch of documents with differing lengths. Doing so causes the false
detection of overlapped documents.
However, if the documents differ in length by 10 mm or less, any document
overlapping will not be detected.
● To scan documents with different lengths, select [Overlapping].
● Even when scanning documents of the same length, if a piece of paper such as a
sticky note, receipt, or photo is attached to a document, the scanner may detect
document overlapping due to the attached paper when [Overlapping] is selected.
In this case, selecting [Length] prevents the false detection of document
overlapping.
- Overlapping and Length
Detects overlapped documents by the combination of [Overlapping] and [Length].
Batch
Continue scanning
Set whether to continue scanning when additional documents are loaded after all
documents loaded in the scanner have been scanned.
Set this to on to continue scanning.
The factory default setting is set to off.
Detect Barcode
Set whether to output the barcode values on documents to index the files.
When [Detect Barcode] is set to on, index files will be created.
The factory default setting is set to off.
For details about barcodes that can be detected, refer to
Specifications of Barcodes (page
419) .
For details about index files, refer to Specifications of Index Files (page 423) .
ATTENTION
When [Destination Type] is set to [Send by E-mail], [Detect Barcode] cannot be used.
When [Detect Barcode] is set to on, specify the following items:
● Barcode Detection Area
DirectScan Settings (Destination/Job/Scan Settings) (Touch Screen)
265