Ricoh fi-8040 Desktop Scanner - Manual (Page 298)

End of page ADF front(mm)
Specify the vertical position (lengthways) at the end of the page for the ADF front.
Main-scan ADF back (mm)
Specify the horizontal position (widthways) for the ADF back.
Sub-scan ADF back (mm)
Specify the vertical position (lengthways) at the top of the page for the ADF back.
End of page ADF back(mm)
Specify the vertical position (lengthways) at the end of the page for the ADF back.
(1): Main-scan ADF front/Main-scan ADF back= -2 to 2 mm
(2): Sub-scan ADF front/Sub-scan ADF back= -2 to 2 mm
(3): End of page ADF front/End of page ADF back= -2 to 2 mm
(in increments of 0.5)
ATTENTION
Normally, you should not have to modify anything as the factory default settings already
use adjusted values.
Magnification
Magnification (%)
Specify the magnification level for the feed direction.
The specified value can range from -3.1 to +3.1% (in increments of 0.1).
The factory default setting is "0.0".
ATTENTION
Normally, you should not have to modify anything as the factory default settings already
use adjusted values.
Scanner Settings (Touch Screen)
298