Ricoh fi-8040 Desktop Scanner - Manual (Page 330)

Offset Setting
Unit
Select [ADF(front)] or [ADF(back)] as the unit for an offset adjustment.
Main
Specify the horizontal (width) offset.
The specified value can range from -2 to +2 mm (in increments of 0.5).
The factory default setting is "0".
Sub
Specify the vertical (length) offset at the top of a page.
The specified value can range from -2 to +2 mm (in increments of 0.5).
The factory default setting is "0".
End of page
Adjust the vertical (length) offset at the end of a page. The specified value can range
from -2 to +2 mm (in increments of 0.5).
(1): Main= -2 to 2 mm
(2): Sub= -2 to 2 mm
(3): End of page= -2 to 2 mm
(in increments of 0.5)
Vertical magnification Adjustment
Unit
The unit for a vertical magnification adjustment is fixed to [ADF].
Magnification
Specify the vertical (length) magnification.
The specified value can range from -3.1 to +3.1% (in increments of 0.1).
The factory default setting is "0.0".
Scanner Settings (Software Operation Panel)
330