Ricoh fi-8040 Desktop Scanner - Manual (Page 235)

●
Is the Roller Set S worn out?
Solution
Check the counters for the consumables using one of the following methods.
● The [Consumable counters] screen on the touch screen
The screen can be displayed in the following procedure:
→ [Cleaning & Maintenance] → [Consumable counters]
● Software Operation Panel
For details, refer to
Clearing the Sheet Counters (page 325) .
If necessary, replace the Roller Set S.
For details, refer to
Replacing the Roller Set S (page 168) .
●
Are you using the scanner at an altitude of 2,000 m or higher?
Solution
If the scanner is being used at an altitude of 2,000 m or higher, use one of the following
methods to enable [High Altitude Mode].
● The [High Altitude Mode] screen on the touch screen
Set [Enable] to on.
The screen can be displayed in the following procedure:
→ [Scanner Settings] → [Paper Source/Feeding] → [High Altitude Mode]
● Software Operation Panel
For details, refer to
Scanning at High Altitude [High Altitude Mode] (page 336) .
HINT
If the scanner is being used on level ground lower than 2,000 m with [High Altitude Mode]
enabled, overlapped documents may not be detected.
If the scanner is being used on level ground lower than 2,000 m, disable [High Altitude
Mode].
Troubleshooting
235