beautypg.com

Gvrp timer leaveall – Allied Telesis AT-FS970M Series User Manual

Page 950

background image

Chapter 61: GARP VLAN Registration Protocol Commands

950

GVRP TIMER LEAVEALL

Syntax

gvrp timer leaveall

value

Parameters

value

Specifies the Leave All Timer in centiseconds. The range is 500 to
3000 centiseconds. The default is 1000 centiseconds.

Mode

Global Configuration mode

Description

Use this command to set the GARP Leave All timer.

Note

The settings for this timer must be the same on all GVRP-active
network devices.

Example

This command sets the Leave All timer to 10 seconds:

awplus> enable
awplus# configure terminal
awplus(config)# gvrp timer leaveall 1000