Allied Telesis AT-FS970M Series - Manual (Page 587)

587
Chapter 39
IGMP Snooping Commands
The IGMP snooping commands are summarized in Table 60 and are
described in detail within the chapter.
Table 60. Internet Group Management Protocol Snooping Commands
Command Mode Description
“CLEAR IP IGMP” on page 588 Privileged Exec Clears all IGMP group membership
records.
“IP IGMP LIMIT” on page 589 Global
Configuration Specifies the maximum number of
multicast addresses the switch is
allowed to learn.
“IP IGMP QUERIER-TIMEOUT” on
page 590 Global
Configuration Specifies the time period in seconds
used by the switch to identify inactive
host nodes and multicast routers.
“IP IGMP SNOOPING” on page 591 Global
Configuration Enables IGMP snooping on the
switch.
“IP IGMP SNOOPING FLOOD-
UNKNOWN-MCAST” on page 592 Global
Configuration Disables the automatic suppression of
unknown multicast traffic.
“IP IGMP SNOOPING MROUTER” on
page 594 Global
Configuration Manually identifies the ports where
multicast routers are connected.
“IP IGMP STATUS” on page 595 Global
Configuration Specifies the IGMP host node
topology, of either single-host per port
or multiple-host per port.
“NO IP IGMP SNOOPING” on
page 596 Global
Configuration Disables IGMP snooping on the
switch.
“NO IP IGMP SNOOPING
MROUTER” on page 597 Global
Configuration Removes multicast router ports.
“SHOW IP IGMP SNOOPING” on
page 598 Privileged Exec Displays the parameter settings and
operational details of IGMP snooping.