Allied Telesis AT-FS970M Series - Manual (Page 687)

AT-FS970M Switch Command Line User’s Guide
687
SHOW LOG PERMANENT
Syntax
show log permanent
Parameters
None
Mode
Privileged Exec mode
Description
Use this command to display the messages in the permanent log. The
event messages are displayed from oldest to newest, one screen at a
time. To cancel the display, type ‘q’ for quit. An example of the log is
shown in Figure 131.
Figure 131. SHOW LOG PERMANENT Command
Table 78 on page 682 describes the columns in the log and Table 79 on
page 683 lists the modules and their abbreviations.
Example
The following example displays the messages in the permanent log:
awplus# show log permanent
. ]>:
-------------------------------------------------------------------------
2010 Jan 15 14:39:04 user.information awplus stp: Set Configuration succeeded
2010 Jan 15 14:39:04 user.information awplus stp: Set Configuration succeeded
2010 Jan 15 14:39:04 user.information awplus stp: Disabled Spanning Tree
2010 Jan 15 14:39:04 user.information awplus stp: Active protocol changed to STP