Allied Telesis AT-FS970M Series - Manual (Page 1109)

AT-FS970M Switch Command Line User’s Guide
1109
SHOW AUTH-MAC INTERFACE
Syntax
show auth-mac interface port
Parameters
port
Specifies a port. You can display more than one port at a time.
Modes
Privileged Exec mode
Description
Use this command to display the parameter settings of the authenticator
ports. This command is equivalent to “SHOW DOT1X INTERFACE” on
page 1114. An example is shown in Figure 190.
Figure 190. SHOW AUTH-MAC INTERFACE Command
Example
This example displays the parameter settings of authenticator ports 1.0.1
through 1.0.4:
awplus# show auth-mac interface port1.0.1-port1.0.4
Authentication Info for interface port1.0.2
portEnabled: Enabled - portControl: Auto
portStatus: UP
reAuthenticate: Disabled
reAuthPeriod: 3600
PAE: quietPeriod: 60 - maxReauthReq: 2 - txPeriod: 30
BE: suppTimeout: 30 - serverTimeout: 30
CD: adminControlledDirections: both
criticalVlan: Disabled
guestVlan: Disabled
dynamicVlanCreation: None
hostMode: Single-Host
dot1x: Enabled
protocolVersion: 1
authMac: Enabled
reAuthRelearning: Disabled