Allied Telesis AT-FS970M Series - Manual (Page 263)

263
Chapter 12
Power Over Ethernet Commands
The Power over Ethernet (PoE) commands are summarized in Table 23.
These commands are only supported on the PoE switches.
Table 23. Power over Ethernet Commands
Command Mode Description
“CLEAR POWER-INLINE
COUNTERS INTERFACE” on
page 265 Privileged Exec Clears the PoE event counters on the
ports.
“NO POWER-INLINE ALLOW-
LEGACY” on page 266 Port Interface Configures ports to deny power to
legacy powered devices (PDs).
“NO POWER-INLINE DESCRIPTION”
on page 267 Port Interface Deletes the PD descriptions.
“NO POWER-INLINE ENABLE” on
page 268 Port Interface Disables PoE on the ports.
“NO POWER-INLINE MAX” on
page 269 Port Interface Restores a port’s power limit to the
default value.
“NO POWER-INLINE PRIORITY” on
page 270 Port Interface Restores a port’s priority setting to the
default Low level.
“NO POWER-INLINE USAGE-
THRESHOLD” on page 271 Global
Configuration Resets the power usage threshold to
the default 80%.
“NO SERVICE POWER-INLINE” on
page 272 Global
Configuration Disables PoE on all of the ports on the
switch.
“NO SNMP-SERVER ENABLE TRAP
POWER-INLINE” on page 273 Global
Configuration Disables the SNMP power-inline trap.
“POWER-INLINE ALLOW-LEGACY”
on page 274 Port Interface Configures a port to support legacy
PDs.
“POWER-INLINE DESCRIPTION” on
page 275 Port Interface Adds a PD description to a port.
“POWER-INLINE ENABLE” on
page 276 Port Interface Enables PoE on a port.
“POWER-INLINE MAX” on page 277 Port Interface Specifies the power limit of a port.