Allied Telesis AT-FS970M Series - Manual (Page 1123)

AT-FS970M Switch Command Line User’s Guide
1123
To configure the switch to send trap or inform messages, you have to add
to one or more of the community strings the IP addresses of the trap and
inform receivers on your network. For trap messages, you must also
specify the format in which the switch should send the messages. The
format can be either SNMPv1 or SNMPv2c. For inform messages, the
format is always SNMPv2c. For instructions, refer to “Adding or Removing
IP Addresses of Trap or Inform Receivers” on page 1126.
You can configure SNMPv1 and SNMPv2c with the SNMPv3 Table
commands described in Chapter 73, ”SNMPv3 Commands” on page 1157.
However, the SNMPv3 Table commands require a much more extensive
configuration.