Allied Telesis AT-FS970M Series - Manual (Page 246)

Chapter 10: Port Parameter Commands
246
SNMP TRAP LINK-STATUS
Syntax
snmp trap link-status
Parameter
None
Mode
Port Interface mode
Description
Use this command to activate SNMP link traps on the ports. The switch
sends an SNMP trap to an SNMP trap receiver on your network whenever
a port experiences a change in its link state.
To disable link traps on a port, refer to “NO SNMP TRAP LINK-STATUS”
on page 220.
Note
For the switch to send SNMP traps, you must activate SNMP and
specify one or more trap receivers. For instructions, refer to Chapter
72, “SNMPv1 and SNMPv2c Commands” on page 1133 or Chapter
73, “SNMPv3 Commands” on page 1157.
Confirmation Command
“SHOW INTERFACE” on page 229
Example
This example activates link traps on port 22:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.22
awplus(config-if)# snmp trap link-status