Allied Telesis AT-FS970M Series - Manual (Page 1876)

Chapter 105: Routing Information Protocol (RIP) Commands
1876
The fields are described in Table 257.
Example
The following example displays routing information, including RIP routes,
on the switch:
awplus# show ip route
Table 257. SHOW IP RIP Command
Parameter Description
Codes Indicates how the destination routing
information is obtained:
 R: RIP
 Rc: RIP connected
 Rs: RIP static
 C: Connected
 S: Static
Network Indicates the IP address and subnet mask
of the destination.
Next Hop Indicates the management IP address of
the next-hop routing device.
Metric Indicates the number of routing devices a
packet must travel through to reach the
destination.
From Indicates the IP address of the source
where the routing information is obtained.
If Indicates the VLAN interface the network
belongs to.