Allied Telesis AT-FS970M Series - Manual (Page 1056)

Chapter 69: 802.1x Port-based Network Access Control
1056
Enabling 802.1x Port-Based Network Access Control on the Switch
To activate 802.1x Port-based Network Access Control on the switch, go
to the Global Configuration mode and enter the AAA AUTHENTICATION
DOT1X DEFAUT GROUP RADIUS command. The command has no
parameters. Here is the command:
awplus> enable
awplus# configure terminal
awplus(config)# aaa authentication dot1x default group
radius
Note
You should configure the RADIUS client on the switch before
activating port-based access control. For instructions, refer to
Chapter 94, “RADIUS and TACACS+ Clients” on page 1457 or
Chapter 95, “RADIUS and TACACS+ Client Commands” on page
1473.