beautypg.com

Configuring the sflow agent 6, Configuring the sflow agent – Allied Telesis AT-FS970M Series User Manual

Page 1186

background image

Chapter 74: sFlow Agent

1186

Configuring the sFlow Agent

The command for defining the IP address of the sFlow collector is the
SFLOW COLLECTOR IP command. The command, which is located in
the Global Configuration mode, has this format:

sflow collector ip

ipaddress

port

udp_port

The IPADDRESS parameter specifies the IP address of the collector and
the UDP_PORT parameter its UDP port. This example specifies the IP
address of the sFlow collector as 154.122.11.24 and the UDP port as
6300:

awplus> enable
awplus# configure terminal
awplus(config)# sflow collector ip 154.122.11.24 port 6300

After configuring the agent, go to the next section to configure the ports
whose performance data is to be sent to the collector.