Allied Telesis AT-FS970M Series - Manual (Page 1736)

Chapter 99: Quality of Service (QoS) Commands
1736
 minimum burst size
 maximum rate
 maximum burst size
The value of the action parameter greatly effects the outcome of this
command. The data for the policed-dscp-transmit option is supplied by the
MLS QOS MAP POLICED-DSCP command. See “MLS QOS MAP
POLICED-DSCP” on page 1720.
Assigning drop-red as an action means that any packets classed as red
are discarded. Although data is metered per byte, if there are sufficient
tokens available that match a part of a packet, then the entire packet is
marked red. It is important to note that if you assign the action parameter
to drop-red, then these packets are dropped.
To remove the associate between a twin-rate policer and a class map, use
“NO POLICE AGGREGATE” on page 1730.
Example
This example configures a twin-rate policer that requires traffic to conform
to a CIR of 11,000 Kbps, a CBS of 13,000 bytes, a PIR of 20,000 Kbps,
and a PBS of 20,000 bytes. This policer re-marks traffic if it does not
conform to the set condition:
awplus> enable
awplus# configure terminal
awplus(config)# policy-map pmap1
awplus(config-pmap)# class classname7
awplus(config-pmap-c)# police twin-rate 11000 13000 20000
20000 action policed-dscp-transmit