Allied Telesis AT-FS970M Series - Manual (Page 1070)

Chapter 70: 802.1x Port-based Network Access Control Commands
1070
“AUTH-MAC REAUTH-
RELEARNING” on page 1085 Port Interface Sets the MAC address learning of the
supplicant (client device) to relearning
for re-authentication on the interface
specified in the Interface command
mode.
“DOT1X CONTROL-DIRECTION” on
page 1086 Port Interface Sets the direction of the filter for the
unauthorized interface.
“DOT1X EAP” on page 1088 Global
Configuration Controls the action of the switch to
EAP packets when 802.1x
authentication is disabled on the
switch.
“DOT1X INITIALIZE INTERFACE” on
page 1090 Port Interface Forces authenticator ports into the
unauthorized state and initializes
authentication.
“DOT1X MAX-REAUTH-REQ” on
page 1091 Port Interface Specifies the maximum number of
times authenticator ports transmit
EAP Request packets to supplicants
before timing out authentication
sessions.
“DOT1X PORT-CONTROL AUTO” on
page 1092 Port Interface Sets ports to the authenticator role.
“DOT1X PORT-CONTROL FORCE-
AUTHORIZED” on page 1093 Port Interface Configures ports to the 802.1x port-
based authenticator role in the forced-
authorized state.
“DOT1X PORT-CONTROL FORCE-
UNAUTHORIZED” on page 1094 Port Interface Configures ports to the 802.1x port-
based authenticator role in the forced-
unauthorized state.
“DOT1X PORT-CONTROL
SUPPLICANT” on page 1095 Port Interface Designates ports as supplicant ports.
“DOT1X SUPPLICANT-PARAMS
AUTH-PERIOD” on page 1096 Port Interface Specifies the time period in seconds
that supplicant ports wait for replies
from authenticators after sending
EAP-Response frames.
“DOT1X SUPPLICANT-PARAMS
HELD-PERIOD” on page 1097 Port Interface Specifies the amount of time in
seconds a supplicant waits to re-
authenticate after an authentication
attempt has failed.
Table 113. 802.1x Port-based Network Access Control Commands (Continued)
Command Mode Description