Spanning-tree stp enable – Allied Telesis AT-FS970M Series User Manual

Page 796

Text mode
Original mode

Chapter 53: STP Commands

796

SPANNING-TREE STP ENABLE

Syntax

spanning-tree stp enable

Parameters

None

Mode

Global Configuration mode

Description

Use this command to enable STP on the switch. You must designate STP
as the active spanning tree protocol on the switch before you can enable it
or configure its parameters. For instructions, refer to “SPANNING-TREE
MODE STP” on page 790.

Confirmation Command

“SHOW RUNNING-CONFIG” on page 166 or “SHOW SPANNING-TREE”
on page 784

Example

This example enables STP on the switch:

awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree stp enable