Allied Telesis AT-FS970M Series - Manual (Page 941)

941
Chapter 61
GARP VLAN Registration Protocol
Commands
The GARP VLAN registration protocol commands are summarized in
Table 99 and described in detail within the chapter.
Table 99. GARP VLAN Registration Protocol Commands
Command Mode Description
“CONVERT DYNAMIC VLAN” on
page 943 VLAN
Configuration Converts dynamic GVRP VLANs and
port assignments to static.
“GVRP APPLICANT STATE ACTIVE”
on page 944 Global
Configuration Enables GIP on the switch.
“GVRP APPLICANT STATE
NORMAL” on page 945 Global
Configuration Disables GIP.
“GVRP ENABLE” on page 946 Global
Configuration Enables GVRP.
“GVRP REGISTRATION” on
page 947 Port Interface Set a port’s GVRP status.
“GVRP TIMER JOIN” on page 948 Global
Configuration Sets the GARP Join Timer.
“GVRP TIMER LEAVE” on page 949 Global
Configuration Sets the GARP Leave Timer.
“GVRP TIMER LEAVEALL” on
page 950 Global
Configuration Sets the GARP Leave All timer.
“NO GVRP ENABLE” on page 951 Global
Configuration Disables GVRP on the switch.
“NO GVRP TIMER JOIN” on page 952 Global
Configuration
Disables the GARP Join Timer.
“NO GVRP TIMER LEAVE” on
page 953 Global
Configuration Disables the GARP Leave Timer.
“NO GVRP TIMER LEAVEALL” on
page 954 Global
Configuration Disables the GARP Leave All timer.
“PURGE GVRP” on page 955 Global
Configuration Disables GVRP on the switch and
returns the timers to their default
values.