Allied Telesis AT-FS970M Series - Manual (Page 1492)

Chapter 95: RADIUS and TACACS+ Client Commands
1492
SHOW RADIUS
Syntax
show radius
Parameters
None
Modes
Privileged Exec mode
Description
Use this command to display the configuration of the RADIUS client. Here
is an example of the client information.
Figure 243. SHOW RADIUS Command
The fields are defined in this table.
Table 154. SHOW RADIUS Command
Parameter Description
Source Interface An IP address assigned to an interface on
the switch that is the source of all
outgoing RADIUS packets. WIth hardware
stacking, this the source address of the
master switch.
Timeout The length of the time, in seconds, that
the switch waits for a response from a
RADIUS server to an authentication
request, before querying the next server
in the list.
Server Host The IP address of a RADIUS server on
the network.
Authentication Port The authentication protocol port.
RADIUS Global Configuration
Source Interface : 192.168.3.97
Timeout : 5 sec
Server Host : 192.168.1.75
Authentication Port : 1812
Accounting Port
: 1813