Allied Telesis AT-FS970M Series - Manual (Page 1200)

Chapter 75: sFlow Agent Commands
1200
SFLOW POLLING-INTERVAL
Syntax
sflow polling-interval
polling-interval
Parameters
polling-interval
Specifies the maximum amount of time permitted between
successive pollings of the packet counters of a port by the agent.
The range is 0 to 16777215 seconds.
Mode
Port Interface mode
Description
Use this command to set the polling intervals for the ports. This controls
the maximum amount of time permitted between successive pollings of
the packet counters on the ports by the sFlow agent. The ports can have
different polling intervals.
To remove sFlow monitoring from a port, enter the NO form of this
command, NO SFLOW POLLING-INTERVAL.
You must disable the sFlow agent to set or change the polling interval of a
port. For instructions, refer to “NO SFLOW ENABLE” on page 1197.
Confirmation Commands
“SHOW SFLOW” on page 1204
Examples
This example sets the polling interval for ports 13 to 15 to 3600 seconds
(one hour):
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.13-port1.0.15
awplus(config-if)# sflow polling-interval 3600