Allied Telesis AT-FS970M Series - Manual (Page 1763)

AT-FS970M Switch Command Line User’s Guide
1763
Figure 274. Mapping of WRR Queues
Use the no form of this command, NO WRR-QUEUE WEIGHT, to remove
the WRR settings from the specified port. In addition, the no form of this
command turns off WRR and turns on strict priority forwarding.
Confirmation Command
“SHOW MLS QOS INTERFACE” on page 1750
Examples
This example assigns queue 0 of port 3 to WRR with a weight of 15:
awplus> enable
awplus# configure terminal
awplus(config)# mls qos enable
awplus(config)# interface port1.0.3
awplus(config-if)# wrr-queue weight 15
This example assigns weights in ascending order to queues 0 through 7 of
port 12 to WRR with weights of 15, 14, 13, 12,11,10, 9, and 8:
awplus> enable
awplus# configure terminal
awplus(config)# mls qos enable
awplus(config)# interface port1.0.12
awplus(config-if)# wrr-queue weight 15,14,13,12,11,10,9,8
This example removes the QoS weight from port 3, turns off WRR, and
turns on Strict Priority forwarding:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.3
awplus(config-if)# no wrr-queue weight
Queue: 0 1 2 3 4 5 6 7
--------------------------------
Weight: 9
8 7 0 0 0 0 0