Allied Telesis AT-FS970M Series - Manual (Page 1240)

Chapter 77: LLDP and LLDP-MED Commands
1240
“LLDP NOTIFICATION-INTERVAL” on
page 1254 Global
Configuration Sets the notification interval, which is
the minimum interval between LLDP
SNMP notifications (traps).
“LLDP REINIT” on page 1255 Global
Configuration Sets the re-initialization delay, which
is the number of seconds that must
elapse after LLDP is disabled on a
port before it can be re-initialized.
“LLDP RUN” on page 1256 Global
Configuration Activates LLDP on the switch.
“LLDP TIMER” on page 1257 Global
Configuration Sets the transmit interval, which is the
interval between regular
transmissions of LLDP
advertisements.
“LLDP TLV-SELECT” on page 1258 Port Interface Specifies the optional LLDP TLVs that
the ports transmit to their neighbors.
“LLDP TRANSMIT RECEIVE” on
page 1261 Port Interface Configures ports to transmit to and/or
accept LLDP and LLDP-MED
advertisements from their neighbors.
“LLDP TX-DELAY” on page 1262 Global
Configuration Sets the value of the transmission
delay timer, which is the minimum
time interval between transmissions of
LLDP advertisements due to a change
in LLDP local information.
“LOCATION CIVIC-LOCATION” on
page 1263 Global
Configuration Creates new LLDP-MED civic location
entries and removes parameter
values from existing entries.
“LOCATION COORD-LOCATION” on
page 1266 Global
Configuration Creates new LLDP-MED coordinate
location entries and removes
parameter values from existing
entries.
“LOCATION ELIN-LOCATION” on
page 1269 Global
Configuration Creates new LLDP-MED ELIN
location entries and removes
parameter values from existing
entries.
“NO LLDP MED-NOTIFICATIONS” on
page 1270 Port Interface Configures the switch not to send
LLDP-MED topology change
notifications when devices are
connected to or disconnected from the
specified ports.
Table 126. LLDP and LLDP-MED Commands (Continued)
Command Mode Description