Allied Telesis AT-FS970M Series - Manual (Page 1879)

AT-FS970M Switch Command Line User’s Guide
1879
SHOW IP RIP INTERFACE
Syntax
show ip rip interface interface
Parameters
interface
Specifies a VLAN interface. This parameter is optional.
Mode
User Exec and Privileged Exec modes
Description
Use this command to display RIP information about the specified VLAN
interface. If no interface is specified, the command displays RIP
information about all of the RIP-enabled VLAN interfaces on the switch.
Figure 286 provides an example of information that the command displays
when you do not specify a parameter.
Figure 286. SHOW IP RIP INTERFACE Command
The fields are described in Table 259.
----------------------------------------------------------------------------
Interface Send Recv Auth Password PoisonReverse AutoSummary
----------------------------------------------------------------------------
vlan2-0 RIP2 BOTH PASS ******** On On
vlan5-0 RIP1 BOTH NONE NOT SET Off On
vlan8-0 RIP2 BOTH PASS ******** On On
Table 259. SHOW IP RIP INTERFACE Command
Parameter Description
Interface Indicates a RIP-enabled VLAN routing
interface.
Send
Indicates the version of RIP packets sent
out the VLAN routing interface. The
version value is one of the following:
 RIP1
 RIP2