Allied Telesis AT-FS970M Series - Manual (Page 1008)

Chapter 66: Voice VLAN Commands
1008
NO SWITCHPORT VOICE VLAN
Syntax
no switchport voice vlan
Parameters
None
Mode
Port Interface mode
Description
Use this command to remove a port from a voice VLAN. A port retains the
CoS priority and DSCP values that were assigned to it when it was a voice
VLAN member.
This command removes LLDP-MED network policy configuration for a
voice device connected to these ports, but does not change the spanning-
tree edge port status.
Confirmation Command
“SHOW VLAN” on page 908
Example
This example removes the voice VLAN assignment from port 1.0.24, and
in turn, disables the transmission of LLDP-MED network policy information
for voice devices on port 1.0.24:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.24
awplus(config-if)# no switchport voice vlan