Allied Telesis AT-FS970M Series - Manual (Page 269)

AT-FS970M Switch Command Line User’s Guide
269
NO POWER-INLINE MAX
Syntax
no power-inline max
Parameters
None
Mode
Port Interface mode
Description
Use this command to restore the default maximum power limits on the
ports. The default power limits are based on the power classes of the PDs.
See “Managing the Maximum Power Limit on Ports” on page 258 for
details.
Confirmation Commands
“SHOW POWER-INLINE” on page 282
“SHOW POWER-INLINE INTERFACE” on page 287
“SHOW POWER-INLINE INTERFACE DETAIL” on page 288
Example
This example restores the default maximum power limit on port 6:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.6
awplus(config-if)# no power-inline max