Allied Telesis AT-FS970M Series - Manual (Page 550)

Chapter 35: Boot Configuration File Commands
550
SHOW BOOT
Syntax
show boot
Parameter
None
Mode
Privileged Exec mode
Description
Use this command to display the name of the active boot configuration file
and the version numbers of the management software and bootloader.
Figure 113 is an example of the information.
Figure 113. SHOW BOOT Command
The fields are described in Table 57.
Table 57. SHOW BOOT Command
Field Description
Current software The version number of the AlliedWare
Plus Management Software on the switch.
Current boot image The version number of the bootloader.
Default boot config The name of the boot configuration file
used by the switch to configure its
parameters after “NO BOOT CONFIG-
FILE” on page 549. This parameter
cannot be changed.
Current boot config The name of the active boot configuration
file on the switch.
Current software: v2.1.1
Current boot image: v2.1.1
Default boot config: /cfg/boot.cfg
Current boot config: /cfg/switch2.cfg (file exists)