Allied Telesis AT-FS970M Series - Manual (Page 227)

AT-FS970M Switch Command Line User’s Guide
227
SHOW FLOWCONTROL INTERFACE
Syntax
show flowcontrol interface port
Parameter
port
Specifies the port whose flow control setting you want to view. You
can specify just one port at a time.
Modes
Privileged Exec mode
Description
Use this command to display the current settings for flow control on the
ports. An example of the information is shown in Figure 52.
Figure 52. SHOW FLOWCONTROL INTERFACE Command
The fields are described in Table 12.
Table 12. SHOW FLOWCONTROL INTERFACE Command
Parameter Description
Port Port number.
Send admin Whether or not flow control is active on
the transmit side of the port. If yes, the
port transmits pause packets during
periods of packet congestion. If no, the
port does not transmit pause packets.
Receive admin Whether or not flow control is active on
the receive side of the port. If yes, the port
stops transmitting packets when it
receives pause packets from the other
network device. If no, the port does not
stop transmitting packets.
PortSendReceive RxPause TxPause
adminadmin
-------------------------- -------
1.0.13yesyes 6520 7823