Allied Telesis AT-FS970M Series - Manual (Page 1539)

1539
Chapter 97
ACL Commands
The Access Control List (ACL) commands are summarized in Table 188
and described in detail within the chapter.
Table 188. Access Control List Commands
Command Mode Description
“ABSOLUTE START” on page 1542 Configuration
Time Range Sets a time range for an associated
permit or deny statement.
“ACCESS-CLASS” on page 1544 Virtual Terminal
Line mode Assigns an ACL to a VTY line.
“ACCESS-GROUP” on page 1546 Port Interface Adds IP ACLs to ports.
“ACCESS-LIST (MAC Address)” on
page 1548 Global
Configuration Creates ACLs that identify packets
based on source and destination MAC
addresses.
“ACCESS-LIST ICMP” on page 1551 Global
Configuration Creates ACLs that identify packets
based on ICMP source and
destination IP addresses.
“ACCESS-LIST IP” on page 1554 Global
Configuration Creates ACLs that filter packets based
on source and destination IP
addresses.
“ACCESS-LIST PROTO” on
page 1558 Global
Configuration Creates ACLs that identify packets
based on protocol numbers and
source and destination IP addresses.
“ACCESS-LIST TCP” on page 1563 Global
Configuration Creates access control lists that filter
ingress packets based on TCP port
numbers.
“ACCESS-LIST UDP” on page 1567 Global
Configuration Creates access control lists that
identify ingress packets based on
UDP port numbers.
“IP ACCESS-LIST” on page 1571 Global
Configuration Creates a Named IP ACL and enters
the IP ACL mode.
“IP ACCESS-LIST (ICMP)” on
page 1572 IP ACL Defines an ACL that filters ICMP
packets based on source and
destination IP addresses.