Allied Telesis AT-FS970M Series - Manual (Page 665)

AT-FS970M Switch Command Line User’s Guide
665
Displaying the Event Log
There are two commands to display the messages stored in the event log.
Both display the same messages and both are found in the Privileged
Exec mode. The only difference is that one displays the messages from
oldest to newest and the other from newest to oldest. The first command is
the SHOW LOG command. If you are more interested in the older
messages, this is the command to use. Here it is:
awplus# show log
The messages are displayed one screen at a time. To cancel the log, type
‘q’ for quit. Here is an example of the log.
Figure 128. SHOW LOG Command
The columns are described in Table 78 on page 682.
If you happen to be interested in the newer messages, use the SHOW
LOG REVERSE command, instead. You will see the same messages, but
the newest are displayed first.
. ]>:
-------------------------------------------------------------------------
2010 Jan 15 14:39:04 user.information awplus stp: Set Configuration succeeded
2010 Jan 15 14:39:04 user.information awplus stp: Set Configuration succeeded
2010 Jan 15 14:39:04 user.information awplus stp: Disabled Spanning Tree
2010 Jan 15 14:39:04 user.information awplus stp: Active protocol changed to STP