Allied Telesis AT-FS970M Series - Manual (Page 199)

199
Chapter 10
Port Parameter Commands
The port parameter commands are summarized in Table 11.
Table 11. Port Parameter Commands
Command Mode Description
“BACKPRESSURE” on page 202 Port Interface Enables or disables backpressure on
ports that are operating in half-duplex
mode.
“BPLIMIT” on page 204 Port Interface Specifies threshold levels for
backpressure on ports.
“CLEAR PORT COUNTER” on
page 205 User Exec and
Privileged Exec Clears the packet counters.
“DESCRIPTION” on page 206 Port Interface Adds port descriptions.
“DUPLEX” on page 208 Port Interface Configures the duplex modes.
“EGRESS-RATE-LIMIT” on page 210 Port Interface Sets a limit on the amount of traffic
that can be transmitted per second
from the port.
“FCTRLLIMIT” on page 211 Port Interface Specifies threshold levels for flow
control.
“FLOWCONTROL” on page 212 Port Interface Enables or disables flow control on
ports that are operating in full-duplex
mode.
“HOLBPLIMIT” on page 215 Port Interface Specifies a threshold for head of line
blocking events.
“NO EGRESS-RATE-LIMIT” on
page 217 Port Interface Disables egress rate limiting on the
ports.
“NO FLOWCONTROL” on page 218 Port Interface Disables flow control on ports.
“NO SHUTDOWN” on page 219 Port Interface Activates disabled ports so that they
resume forwarding network traffic
again.
“NO SNMP TRAP LINK-STATUS” on
page 220 Port Interface Deactivates link traps.