Allied Telesis AT-FS970M Series - Manual (Page 1676)

Chapter 99: Quality of Service (QoS) Commands
1676
“MATCH TCP-FLAGS” on page 1704 Class Map Sets one or more TCP flags for a
class map.
“MATCH VLAN” on page 1706 Class Map Sets a VLAN ID for a class map.
“MLS QOS AGGREGATE-POLICE
SINGLE-RATE” on page 1707 Policy Map
Class mode Configures a single-rate policer for a
class map and creates a police
aggregator.
“MLS QOS AGGREGATE-POLICE
TWIN-RATE” on page 1710 Policy Map
Class mode Configures a twin-rate policer for a
class map and creates a police
aggregator.
“MLS QOS COS” on page 1713 Interface
Configuration Assigns a Class of Service (CoS)
user-priority value to untagged frames
that enter the specified interface.
“MLS QOS ENABLE” on page 1715 Global
Configuration Activates QoS on the switch. This
feature is disabled by default.
“MLS QOS MAP COS-QUEUE” on
page 1716 Global
Configuration Maps CoS priorities to egress queues.
“MLS QOS MAP DSCP-QUEUE” on
page 1718 Global
Configuration Maps DSCP priorities to egress
queues.
“MLS QOS MAP POLICED-DSCP” on
page 1720 Global
Configuration Maps an existing DSCP to a new
DSCP value.
“NO AUTO-QOS VOICE | TRUST
DSCP” on page 1722 Interface
Configuration Disables Auto-QoS support for a voice
VLAN and specifies CoS or DSCP
trusted traffic.
“NO MATCH ACCESS-GROUP” on
page 1724 Class Map
Mode Removes an ACL name or number
from a class map.
“NO MATCH PROTOCOL” on
page 1726 Class Map
Mode Removes an Ethernet format and a
protocol from a class map.
“NO MLS QOS AGGREGATE-
POLICE” on page 1728 Global
Configuration Removes an association between a
police aggregator and a class map.
“NO MLS QOS ENABLE” on
page 1729 Global
Configuration Disables QoS on the switch.
“NO POLICE AGGREGATE” on
page 1730 Policy Map
Class Disables a policer configured on a
class map.
“POLICE AGGREGATE” on
page 1731 Policy Map
Class Associates an aggregate name with a
class map.
Table 231. Quality of Service Commands (Continued)
Command Mode Description