Allied Telesis AT-FS970M Series - Manual (Page 195)

AT-FS970M Switch Command Line User’s Guide
195
Displaying Port Settings
There are several ways to display port settings. See the following:
 “Displaying Speed and Duplex Settings” on page 195
 “Displaying Port Status” on page 195
 “Displaying Port Configuration” on page 196
Displaying Speed
and Duplex
Settings
To display the speed and duplex mode settings of the ports, use the
SHOW INTERFACE STATUS command in the Privileged Exec mode.
Here is the format:
show interface [ port ] status
This example of the command displays the speed and duplex mode
settings for ports 18 and 20:
awplus# show interface port1.0.18,port1.0.20 status
Here is an example of the information the command displays.
Figure 48. SHOW INTERFACE STATUS Command
The columns are described in Table 15 on page 235. For a description of
the command, see “SHOW INTERFACE STATUS” on page 235.
Displaying Port
Status
To display the current status of the ports on the switch, use the SHOW
INTERFACE command in the Privileged Exec mode. Here is the format:
show interface [ port ]
This example displays the settings for ports 1 and 2:
awplus# show interface port1.0.1,port1.0.2
See Figure 49 on page 196 for an example of the display.
Port Name Status Vlan Duplex Speed Type
port1.0.18 Port_01 down 3 half 100 10/100/1000Base-T
port1.0.20 Port_02 up 11 auto auto 10/100/1000Base-T