Allied Telesis AT-FS970M Series - Manual (Page 1649)

AT-FS970M Switch Command Line User’s Guide
1649
The following example sets ingress traffic with a CoS value of 5 to egress
on queue 7 of port 8:
Table 216. Setting Egress CoS Queues Example
Command Description
awplus> enable Enters the Privileged Executive mode from the
User Executive mode.
awplus# configure terminal Enters the Global Configuration mode.
awplus(config)# mls qos enable Activates the QoS feature on the switch.
awplus(config)# class-map trustcos Creates a class map called “trustcos” and enters
the Class Map mode.
awplus(config-cmap)# exit Exits the Class Map mode.
awplus(config)# policy-map pmap1 Creates a policy map called “pmap1.”
awplus(config-pmap)# class trustcos Adds class map “trustcos” to policy map “pmap1.”
awplus(config-pmap-c)# exit Exits the Policy Map Class mode.
awplus(config-pmap)# exit Exits the Policy Map mode.
awplus(config)# interface port1.0.8 Enters the Port Interface mode for port 8.
awplus(config-if)# service-policy
input pmap1 Attaches policy map “pmap1” to port 8.
awplus(config-if)# mls qos map cos-
queue 5 to 7 Maps priority 5 to queue 7 on port 8.
awplus(config-if)# end Exits the Port Interface mode.
awplus# show mls qos maps cos-queue
interface port 1.0.8 Displays the CoS mapping for port 8. See below.
COS:01 2 34567
--------------------------------
QUEUE:20
1 34567