Allied Telesis AT-FS970M Series - Manual (Page 676)

Chapter 44: Event Log Commands
676
LOG PERMANENT
Syntax
log permanent [level level ]|[program program ]|
[msgtext msgtext ]
Parameters
level
Specifies the minimum severity level of the event messages to be
stored in the permanent log. The severity levels are listed in
Table 77 on page 672.
program
Specifies the event messages of a particular management
software module. The modules are listed in Table 79 on page 683.
To specify more than one module, separate the modules with
commas.
msgtext
Specifies a text string with double quotations around to match the
event messages. This string is case sensitive and must be the last
text on the command line.
Mode
Global Configuration mode
Description
Use this command to specify the types of event messages to be stored in
the permanent log. You can specify the messages by severity level,
management software module, a text-string within the message or a
combination of some or all of these.
Confirmation Command
“SHOW LOG CONFIG” on page 685