Allied Telesis AT-FS970M Series - Manual (Page 1144)

Chapter 72: SNMPv1 and SNMPv2c Commands
1144
SHOW SNMP-SERVER
Syntax
show snmp-server
Parameters
None
Mode
Privileged Exec mode
Description
Use this command to display the current status of SNMP on the switch. An
example is shown in Figure 202. The first field displays whether SNMP is
enabled or disabled on the switch. You can remotely manage the switch
with SNMPv1 or v2c when the server is enabled. Remote management is
not possible when the server is disabled. To activate or deactivate SNMP,
refer to “SNMP-SERVER” on page 1148 and “NO SNMP-SERVER” on
page 1135, respectively.
Figure 202. SHOW SNMP-SERVER Command
Example
This example displays the current status of SNMP on the switch:
awplus# show snmp-server
SNMP Server ....... Enabled
IP Protocol ....... IPv4
SNMPv3 Engine ID (Configured) ........ Not set
SNMPv3 Engine ID (actual) ............ 0x80001f8880241d7f08386d438e