Allied Telesis AT-FS970M Series - Manual (Page 648)

Chapter 42: DHCP Snooping Commands
648
SHOW ARP SECURITY INTERFACE
Syntax
show arp security interface
Parameters
interface
Indicates the list of ports. If no ports are specified, information for
all ports is displayed.
Mode
Privilege Exec mode
Description
Use this command to display ARP security configuration for the specified
ports or all ports.
Example
This example displays ARP security configuration for ports 1 through 7:
awplus> enable
awplus# show arp security interface port1.0.1-port1.0.7
See Figure 121 for a sample display. See Table 71 on page 649 for an
explanation of the parameters in this display.
Figure 121. SHOW ARP SECURITY INTERFACE Command
awplus# show arp security interface port1.0.1-port1.0.5
Arp Security Port Status and Configuration:
Port: Provisioned ports marked with brackets, e.g. (portx.y.z)
KEY: LG = Log
TR = Trap
LD = Link down
Port Action
----------------------------------------
port1.0.1
LG TR --
port1.0.2 -- -- --
port1.0.3 LG TR LD
port1.0.4 LG -- --
port1.0.5 LG -- LD