Allied Telesis AT-FS970M Series - Manual (Page 509)

AT-FS970M Switch Command Line User’s Guide
509
NO GROUP-LINK-CONTROL DOWNSTREAM
Syntax
no group-link-control group downstream group_id
Parameter
group_id
Specifies a group ID number. The range is 1 through 8. The group
must already exist.
Mode
Port Interface mode
Description
Use this command to remove downstream ports from groups in group link
control. You may remove more than one port at a time from groups.
Note
Downstream ports that group link control has disabled remain
disabled when removed from a group. To manually activate the
ports, use the NO SHUTDOWN command. For instructions, refer to
“Enabling or Disabling Ports” on page 184 or “NO SHUTDOWN” on
page 219.
Confirmation Command
“SHOW GROUP-LINK-CONTROL” on page 511
Examples
This example removes downstream port 3 from group ID 5:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.3
awplus(config-if)# no group-link-control downstream 5
This example removes downstream ports 14 and 15 from group ID 7:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.14,port1.0.15
awplus(config-if)# no group-link-control downstream 7