Allied Telesis AT-FS970M Series - Manual (Page 272)

Chapter 12: Power Over Ethernet Commands
272
NO SERVICE POWER-INLINE
Syntax
no service power-inline
Parameters
None
Mode
Global Configuration mode
Description
Use this command to disable PoE on the switch. The ports do not transmit
power to the PDs when PoE is disabled, but they do forward network
traffic. The default setting for PoE is enabled.
Confirmation Commands
“SHOW POWER-INLINE” on page 282
“SHOW POWER-INLINE INTERFACE” on page 287
“SHOW POWER-INLINE INTERFACE DETAIL” on page 288
Example
This example disables PoE on the switch:
awplus> enable
awplus# configure terminal
awplus(config)# no service power-inline