Allied Telesis AT-FS970M Series - Manual (Page 256)

Chapter 11: Power Over Ethernet
256
Adding PD Descriptions to Ports
PDs connected to the ports are easier to identify if you give them
descriptions. To add descriptions to PDs, use the POWER-INLINE
DESCRIPTION command in the Port Interface mode. Here is the format:
power-inline description description
The description parameter can consist of up to 256 alphanumeric
characters. Spaces and special characters are allowed. You can assign a
description to more than one port at a time. See “POWER-INLINE
DESCRIPTION” on page 275.
To remove the current description from the port without assigning a new
one, use the NO POWER-INLINE DESCRIPTION command. See “NO
POWER-INLINE DESCRIPTION” on page 267.
This example adds a PD description of “Desk Phone” to port 1.0.5 and
port1.0.6:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.5,port1.0.6
awplus(config-if)# power-inline description Desk Phone
This example removes the description previously added to the port 6:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.6
awplus(config-if)# no power-inline description
Note
To add a general description to a port, use the DESCRIPTION
command. For more information, see “DESCRIPTION” on
page 206.