Allied Telesis AT-FS970M Series - Manual (Page 1608)

Chapter 97: ACL Commands
1608
time-range
Specifies the name of a time range that is created with the TIME-
RANGE command. You must create a time range before entering it
as a parameter value. See “TIME-RANGE” on page 1624.
vid
Indicates a VLAN identifier. Specify a VLAN if you want the ACL to
filter tagged packets. Omit a VLAN if you want the ACL to filter
untagged packets. Specify a value between 1 and 4094. You can
enter only one VID.
Mode
Configuration IPv6 ACL mode
Description
Use this command to create IPv6 access control lists that filter ingress
packets based on UDP port numbers.
Examples
This example creates a UDP-based IPv6 ACL list that discards UDP
packets from any source IP address and to any destination IP address.
Then the ACL is assigned to port 6:
awplus> enable
awplus# configure terminal
awplus(config)# ipv6 access-list udpdeny
awplus(config-ipv6-acl)# deny udp any any
awplus(config-ipv6-acl)# exit
awplus(config)# interface port1.0.6
awplus(config_if)# ipv6 traffic-filter udpdeny
This example creates a UDP-based IPv6 ACL list, named
“udpcopytomirror,” that copies all ingress UDP packets that match the
ACL to the destination port of the mirror port. Then the ACL is assigned to
port 20:
awplus> enable
awplus# configure terminal
awplus(config)# ipv6 access-list udpcopytomirror
awplus(config-ipv6-acl)# copy-to-mirror udp any any
awplus(config-ipv6-acl)# exit
awplus(config)# interface port1.0.20
awplus(config_if)# ipv6 traffic-filter udpcopytomirror