Allied Telesis AT-FS970M Series - Manual (Page 507)

AT-FS970M Switch Command Line User’s Guide
507
GROUP-LINK-CONTROL UPSTREAM
Syntax
group-link-control upstream group_id
Parameter
group_id
Specifies a group ID number. The range is 1 through 8. The group
must already exist.
Mode
Port Interface mode
Description
Use this command to add upstream ports to groups in group link control.
You may add more than one port at a time. The group must already exist.
For instructions on how to create groups, refer to “GROUP-LINK-
CONTROL” on page 504.
Use the NO form of this command, NO GROUP-LINK-CONTROL
UPSTREAM, to remove upstream ports from groups.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 166
Examples
This example adds port 5 as an upstream port to group ID 4:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.5
awplus(config-if)# group-link-control upstream 4
This example assigns ports 20 through 22 as upstream ports to group ID
8:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.20-port1.0.22
awplus(config-if)# group-link-control upstream 8