Allied Telesis AT-FS970M Series - Manual (Page 1096)

Chapter 70: 802.1x Port-based Network Access Control Commands
1096
DOT1X SUPPLICANT-PARAMS AUTH-PERIOD
Syntax
dot1x supplicant-params auth-period value
Parameters
value
Specifies the authentication timeout period for supplicant ports.
The range is 1 to 300 seconds. The default is 30 seconds.
Mode
Port Interface mode
Description
Use this command to specify the time period in seconds that supplicant
ports wait for replies from authenticators after sending EAP-Response
frames. The range is 1 to 300 seconds.
Confirmation Command
“SHOW RUNNING-CONFIG INTERFACE” on page 240
Example
This example sets the authentication timeout period on supplicant ports
1.0.4 and 1.0.5 to 80 seconds:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.4,port1.0.5
awplus(config-if)# dot1x supplicant-params auth-period 80