Allied Telesis AT-FS970M Series - Manual (Page 1028)

Chapter 68: MAC Address-based Port Security Commands
1028
SHOW PORT-SECURITY INTERFACE
Syntax
show port-security interface port
Parameters
port
Specifies the port whose security mode settings you want to view.
You can display more than one port at a time.
Mode
Privileged Exec mode
Description
Use this command to display the security settings of the ports on the
switch. An example of the information is shown in Figure 181.
Figure 181. SHOW PORT-SECURITY INTERFACE Command
The fields are described in Table 109.
Table 109. SHOW PORT-SECURITY INTERFACE Command
Field Description
Port Port number.
Security Enabled The current status of MAC address-based
security on the port. The security is active
if the status is Yes and inactive if the
status is No. To activate or deactivate
security on the port, refer to
“SWITCHPORT PORT-SECURITY” on
page 1033 or “NO SWITCHPORT PORT-
SECURITY” on page 1026, respectively.
Port Security Configuration - Port1.0.15
----------------------------------------------
Security Enabled
: YES
Port Status : ENABLED
Violation Mode : PROTECT
Aging : NO
Maximum MAC Addresses : 0
Current Learned Addresses : 0
Lock Status
: UNLOCKED
Security Violation Count : 0